безплатна доставка
на поръчки над 99 лв.
02 4372440
Cart Cart

Glorious Ascended Cable V2

Кабел за мишка Glorious Ascended Cable V2 - Glorious Gold

Арт. номер: GL-CABLE-GAMO-848
наличен

Запитване за Glorious Ascended Cable V2

безплатна доставка
на поръчки над 99 лв.
Технически характеристики
Съвместимост Мишки
Тип аксесоар Кабел

Ascended Cord Replacement Kit

Say goodbye to 3rd party paracord mods, and say hello to the Ascended Cord. Our proprietary braided cable is ultra-flexible and super lightweight, giving your mouse an almost wireless feel.

This is a replacement cable kit for Model O/O- and D/D-. 

Tutorial on how to change Ascended Cord on your Model O/O-/D/D- here

Note: Opening the Glorious Model O/O-/D/D- mouse to install our Ascended cable will NOT void the warranty, so long as you follow given instructions. Modifying your mouse in any other way while it is open will still void it.

ASCENDED CABLE INSTALLATION INSTRUCTIONS

GLORIOUS ASCENDED CABLE QUICK INSTALLATION GUIDE

Tools Needed:

  • Flat head screwdriver
  • Philips head screwdriver
  • Microfiber cloth

Quick Steps:

  1. Remove bottom two G-Skates under the logo with a flat head screwdriver. Do not worry about damaging skates as each replacement cable kit will come with brand new G-Skates.
  2. Unscrew the housing using a Philips head screwdriver.
  3. Detach the housing by pulling back on the housing towards the scroll wheel then pull up gently. Be aware of the black strips that are attached to the circuit board. Do not remove these.
  4. Unplug the old cable by pulling on the white plug gently. Remove the wiring from the base of the mouse. Then remove the SR Cable under the scroll wheel.
  5. Grab your new Ascended cable and plug in the white plug into the board of the mouse. Make sure to use the right side of the plug.
  6. Route the wiring between the two pegs on the base of the mouse and place the SR Cable of your new Ascended cable in its designated housing in front of the scroll wheel. Make sure that there is ample room in front of that scroll wheel.
  7. Place the housing back on and screw them in place.
  8. Wipe clean the G-Skate housing area.
  9. Peel the G-Skate adhesive and place them accordingly into the G-Skate border area. Press firmly for a few seconds to secure the G-Skate on to your Model O.
  10. NOTE: If your mouse does not work or partially works when you plug it in to your computer (no RGB or sensor response, but mouse buttons work), then you need to run the Glorious Model O/O- software as administrator and click Restore, then hit APPLY. 
  11. Now you are good to go. Stay Glorious!